Satel INTEGRA Plus Uživatelský manuál stáhnout pdf (Strana 41)

SATEL INTEGRA Plus 39

7. Using the entry keypad

The INT-SCR multifunction keypad can work in the entry keypad mode (INT-ENT). The main

task of the zone keypad is activation of the delay for the 3. INTERIOR DELAYED type zones. The

time period during which these zones will act as delayed ones is programmable for the

keypad. If more than one zone keypads are assigned to the partition, a different delay

unblocking time can be programmed for each of them. After expiry of the programmed time,

the interior delayed zones will again operate as instant ones.

7.1 LED indicators

Only the LED

is used. Blinking of the LED indicates that the delay activation time

countdown is running (disarming has no effect on the LED blinking).

7.2 Sound signaling

The installer can disable the sound signaling or replace it by blinking of keypad

backlight.

During operation, the keypad can generate the following sounds:

1 short beep – pressing any digit key, confirmation that code has been entered or card has

been read.

3 short beeps – confirmation of delay activation.

4 short and 1 long beeps – confirmation of the guard round or execution of the control for

24. MONO SWITCH or 25. BI SWITCH type outputs.

3 pairs of short beeps – the user should change his/her code.

2 long beeps – unknown code/card.

3 long beeps – activation the delay is impossible (the partition is disarmed or the delay has

already been started) or the function is unavailable.

Additionally, the keypad can audibly signal the DELAY ACTIVATION TIME.

7.3 Functions available from the entry keypad

Depending on the user type and authority level, keypad settings and alarm system status,

entering the code and confirming it with the

or key (presenting the proximity card) will

result in:

– activating the delay in partition for 3. I

NTERIOR DELAYED type zones;

– changing over the status of 25. BI SWITCH type outputs;

– turning on the 24. MONO

SWITCH type outputs;

– guard round confirmation.

8. Using the code lock

The basic task of the code lock is to execute the access control function (supervise a single

door).

SATEL offers the following code locks:

INT-SZ;

INT-SZK.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Komentáře k této Příručce

Žádné komentáře

Satel INTEGRA Plus Uživatelský manuál Strana 41

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Satel INTEGRA Plus