
28 User Manual SATEL
5.8.5 Adding proximity card / DALLAS iButton
1. When adding or editing a user, run the NEW PROX. CARD / NEW DALLAS function.
2. Using the and keys, select how the card / iButton is to be added. The number of
card / iButton can be read by a selected reader (device equipped with a reader) or
entered manually.
3. Press the
key
.
4. If the number of card / iButton is to be read, read in the card / iButton twice, following the
instructions appearing on the keypad display. When the read number of card / iButton is
displayed, press the
key.
5. If the number of card / iButton is to be entered, enter it from the keypad, and then press
the
key.
7. You will be brought back to the list of functions for defining the user parameters. Instead
of the NEW PROX. CARD / NEW DALLAS function, the REMOVE PROX. CARD / REMOVE
DALLAS function will be available. Press the key.
6. When a prompt appears, asking you if the changes are to be saved, press the 1 key.
Proximity cards / DALLAS iButtons are added to the master users (administrators) in
the same way.
5.8.6 Adding keyfob
1. When adding or editing a user, run the NEW RX KEYFOB / NEW ABAX KEYFOB function
(depending on which keyfob is to be added).
2. Using the and keys, select how the keyfob is to be added. The number of keyfob
can be read during transmission by a device supporting keyfobs or entered manually.
3. Press the
key
.
4. If the keyfob number is to be read, press twice the keyfob button according to the
instructions displayed on the keypad. When the keyfob number is displayed, press the
key.
5. If the keyfob number is to be entered, enter it from the keypad, and then press the
key.
6. You will be brought back to the list of functions for defining the user parameters. Instead
of the N
EW RX KEY FOB / NEW ABAX KEYFOB function, the REM. RX KEY FOB / REM.ABAX
KEYFOB
function will be available. Additionally, some functions appear to allow you to
configure the keyfob.
Prior to assigning the zones to buttons / combinations of buttons, consult the installer.
Numeration of the keyfob buttons and LEDs is described in section OPERATING THE
ALARM SYSTEM BY MEANS OF KEYFOB (p. 43).
7. Using the key, find the BUTTON 1 function in the list, and then press the
key.
8. Using the and keys, select which zone is to be violated on pressing the 1 button in
the keyfob (you can also enter the zone number from the keypad), and then press the
key.
9. Repeat the steps 7 and 8 for other buttons / combinations of buttons which are to be
used.
10. Using the key, find the EVENTS (RX) / EVENTS (ABAX) function in the list.
11. Press the
key. The list of buttons / combinations of buttons will be displayed. In the
upper right-hand corner of the display, an additional symbol is located:
– pressing the button / combination of buttons is written to the event log (default
setting);
Komentáře k této Příručce