Satel INTEGRA Plus Uživatelský manuál stáhnout pdf (Strana 25)

SATEL INTEGRA Plus 23

5.4.5 Denial of arming

The installer can program the control panel so that the arming procedure could not be

started, if:

– a zone is violated in the partition;

– there is a trouble in the system (including tamper);

– there was a verified alarm.

The keypad will inform you about the refusal to arm by means of a message specifying the

cause for refusal.

If after a verified alarm the arming is impossible, the installer must be called. The

arming will only be possible after the installer intervention (see: description of the

SYSTEM RESET function, p. 16).

Bypassing violated zones when arming

If the arming procedure could not be started, and a message on the display informs you that

there are violated zones, you can review the list of such zones upon pressing the 2 key. To

scroll through the list, use the  and  keys. Pressing the 4 key will allow you to bypass the

given zone. A message on the display will prompt you to press the 1 key to confirm that the

zone is to be bypassed.

Forced arming

If the arming procedure could not be started, the displayed message can allow of the forced

arming (1=Arm). On pressing the 1 key, the system will be armed despite a violated zone or a

trouble.

5.4.6 Failure of arming procedure

If the installer has enabled the GRADE 3 option, the arming procedure may end in failure. The

system will not be armed, if at the end of the exit delay countdown:

– there is a violated zone in partition which was not violated when the arming procedure

was started;

– there is a trouble which did not exist when the arming procedure was started.

5.4.7 Shortening the exit delay time

If such an option is permitted by the installer, the partition exit delay time may be shortened

upon pressing in turn the 9 and

keys.

5.5 Disarming and alarm clearing

Enter the code and confirm with the

key

(see: section [CODE] – ARMING / DISARMING MENU

p. 10). If only selected partitions are to be disarmed (DISARM SELECTED function), the

partitions should be selected in the same way as when arming the selected partitions.

5.5.1 Alarm clearing without disarming

1. Enter the code and confirm with the

key

2. Using the  key, scroll through the menu until the CLEAR ALARM function is found.

3. Press the

key

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Satel INTEGRA Plus Uživatelský manuál Strana 25

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Satel INTEGRA Plus