Satel INTEGRA Plus Uživatelský manuál stáhnout pdf (Strana 17)

SATEL INTEGRA Plus 15

[42] Isolate

[5] Events

[51] Selected events

[52] All events

[6] Set time

[7] System state

[8] Outputs control

[9] Service mode

[0] Downloading

[01] Start DWNL-RS

[02] Finish DWNL-RS

[03] Start DWNL-MOD.

[04] Start DWNL-TEL

[07] ETHM-1 – DloadX

[08] ETHM-1 – GuardX

5.3.4 Entering data by means of the LCD keypad

Data are saved to the control panel if you press the key (in some keypads, the key is

also available, whose function is exactly the same). The key enables exiting the function

without saving any changes.

Described below are general rules for entering data, however they may be different as

regards some functions.

Selection from the single-choice list

Shown in the upper line of display is description of the function, and in the lower one – the

currently selected item. You can scroll through the list of items, using the direction keys: 

(down) and  (up). The  and  keys are not used.

Selection from the multiple-choice list

The functions that allow you to make multiple choice can be identified by an additional

symbol situated at the right-hand side of the display:

– displayed item is selected / option is enabled;

– displayed item is not selected / option is disabled.

Press any numeric key to change the currently displayed symbol to another one. To scroll the

list of items, use the  (down) or  (up) key.

For some functions, pressing the  or  key will switch the keypad into the graphic

programming mode. The and symbols are used to present on the display the current

status of up to 32 items available in the given function (these can be e.g. zones, outputs,

timers, etc.). Additionally, in case of zone bypassing, the

symbol is used. The  key moves

the cursor to the right, and the  key to the left. If the list of items is longer than 32, pressing

the  key when the cursor is placed over the last item will display the next list, and pressing

the  key when the cursor is placed over the first item will display the previous list (see also

description of the

LEDs, p. 8). Pressing the key 0, 1 or 2 three times in the graphic mode

within 3 seconds will have the following effect:

000 -

the symbol will be displayed at all available items;

111 - the symbol will be displayed at all available items;

222 - reversal of the selection made: the symbol will be displayed at all items where

the symbol was displayed, and the symbol where the symbol was displayed.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Satel INTEGRA Plus Uživatelský manuál Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Satel INTEGRA Plus