Satel INTEGRA Plus Uživatelský manuál stáhnout pdf (Strana 22)

20 User Manual SATEL

zone status is shown using the following symbols (which can be changed by the

installer):

b - zone bypass,

l - trouble "long violation",

f - trouble "no violation",

T - tamper alarm,

A - alarm,

- zone tamper,

M - masking,

- zone violation,

t - tamper alarm memory,

m - masking memory,

a - alarm memory,

- zone OK.

Supply voltages – available to the installer. Enables checking of the supply voltage for

individual expansion modules.

Temperatures – allows to check the temperatures measured by ATD-100 wireless

detectors.

Radio devices – allows to check the radio signal level for ABAX system wireless devices

supported by the control panel.

Zone Test – the submenu contains functions which allow to test the detectors connected

to the zones (see: section ZONE TESTING p. 33).

Battery test – available to the installer. Upon starting the function, the control panel will

generate events to inform about the status of batteries of the control panel and

hardwired expansion modules with power supply. Additionally, the status of 60. TECH.-

BATTERY LOW type zones will be analyzed.

Manual transmission test – generates an event, which starts the procedure of event

transmission to the monitoring station (a code sent with the system identifier).

Monitoring station test (1A, 1B, 2A, 2B) – allows to send a test transmission to the

monitoring station (separate functions for each of the telephone numbers). When

sending the transmission, messages are displayed to inform about the currently

performed operation. The function is useful when starting the reporting or in case of any

reporting trouble.

Messaging test – allows to test the messaging function. Upon starting the function:

1. Enter the number of the telephone (consecutive number on the telephone list).

2. Press the  key.

3. Enter the number of voice message.

4. Press the

key. The control panel will call the indicated number and play back the

message.

Answering test – if this function is started, information on the number of rings and going

off-hook is displayed when answering the telephone call.

Proximity card test – allows to check the number of proximity card and establish to whom

it belongs (if the card belongs to a user of the system).

CA-64 PTSA test – allows to test the mimic board.

View masters – available to the administrator. It makes it possible to check in which

objects the master users are created.

Keypad name – allows to check the given keypad name.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Satel INTEGRA Plus Uživatelský manuál Strana 22

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Satel INTEGRA Plus