Satel INTEGRA Plus Uživatelský manuál stáhnout pdf (Strana 39)

SATEL INTEGRA Plus 37

6.1.4 Sound signaling

Beeps generated when operating

The installer can disable the sound signaling or replace it with blinking of the keys

backlight.

1 short beep – pressing any digit key, confirmation that code has been entered or card has

been read.

2 short beeps – acceptance of the first code during two code arming / disarming.

3 short beeps – signaling of:

– starting the procedure of arming (if no exit delay time has been programmed for the

partition, this is equivalent to arming),

– disarming and/or alarm clearing.

4 short and 1 long beeps – confirmation that the function has been executed.

3 pairs of short beeps – the user should change his/her code.

1 long beep – refusal to arm (there are violated zones in the partition or there is a trouble).

2 long beeps – unknown code/card.

3 long beeps – unavailable function.

Events signaled by sounds

Only installer selected events are signaled.

Alarms are signaled for the time programmed by the installer.

5 short beeps – zone violation (CHIME).

Long beep every 3 seconds, followed by a series of short beeps for 10 seconds

and 1 long beep – countdown of exit delay (if the time is shorter than 10 seconds, only

the final sequence of short beeps will be generated).

A sequence of 7 beeps of diminishing duration, repeated every few seconds –

countdown of auto-arming delay.

2 short beeps every second – countdown of entry delay.

Continuous beep – alarm.

Long beeps every 2 seconds – alarm memory.

Long beep every second – fire alarm.

Short beeps every 2 seconds – fire alarm memory.

Very short beeps – door open too long.

6.2 Functions available from the partition keypad

6.2.1 [Code]

Depending on the user type and authority level, keypad settings and the alarm system status,

entering the code and confirming with the

key will result in:

– unlocking the door (activating the relay);

– disarming the partition;

– clearing alarm;

– changing over the status of 25. BI

SWITCH type outputs;

– turning on the 24. MONO

SWITCH type outputs;

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Satel INTEGRA Plus Uživatelský manuál Strana 39

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Satel INTEGRA Plus