Satel CA-10 Uživatelský manuál stáhnout pdf (Strana 21)

CA-10 SATEL

After calling the function, the control panel generates two short beeps and waits for the

output number key (1-6) to be pressed. The control consists in changing over the status

of the given output to its opposite, i.e. the inactive output gets activated and vice versa.

Provision is made for multiple control of the same output or control of different outputs

of the SWITCH BI type after single calling of the function. Activation of the output is

confirmed by four short and one long beeps, and its deactivation - with three short

beeps. Refusal of control is signaled with two long beeps. The control panel may refuse

control, if the output is not of the SWITCH BI type or if it belongs to another partition.

Pressing the keys [#] or [

] will end the function. The control panel will automatically

terminate the function if none of the outputs is of the SWITCH BI type, or if no key on

the keypad is depressed for 40 seconds.

The function is accessible to the master user, as well as to the users with authority

levels 1 and 6.

Power supply reset [CODE][

][9]

This function is used to operate special detectors equipped with individual on/off

memory which is cleared by powering down the system (e.g., smoke detectors, broken

glass detectors). The function temporarily disconnects power supply to such detectors

(on „RESET power supply” outputs).

The function is available to the master user and users with authority level 1.

Telephone DOWNLOADING start [CODE][

][0]

This function can be activated by the master user and the users with authority level 1. It

starts the control panel - service PC telephone connection. The function enables the

panel - PC telephone communication, when the possibility to initiate connection from the

PC computer is blocked.

On activating the function the panel engages the telephone line and connects to the

service computer. If the panel fails to establish connection, it will make four more

attempts to get through. During the data exchange the telephone line will be busy. The

service can temporarily suspend the connection to free the telephone line and, after

some time, call back the panel to continue data exchange. The installer should make

users aware of the procedure so that they do not answer the incoming calls and allow

re-establishing and correct completion of the transmission.

Viewing events log (additional function in the LCD keypad)

On activating the function, the users can view the memory log in which all the events

are recorded in detail. The  keys enable scrolling through the list of events, and the

 keys make it possible to get extra information: zone descriptions, partition and user

names.

http://www.ealarm.com.my

1 2 ... 16 17 18 19 20 21 22 23

Žádné komentáře

Satel CA-10 Uživatelský manuál Strana 21