Satel CA-10 Uživatelský manuál Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 23
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
CA-10 SATEL
9
tone followed by a 4-second pause - this signal corresponds to the telephone
ringing tone) hang up and call again (within 5 minutes) - the panel will answer the
second call immediately.
The installer decides if the function is to be activated and how the control panel will
answer the phone calls (number of rings, double calling, etc.)
Control panel interfacing with DTMF (MST-1) control module
The control panel can support a module which can enable the user to perform remotely,
by means of a telephone and DTMF signals, the following operations:
check the state of partitions (armed, alarm)
check the state of zones (which of them are violated)
arm / disarm
clear alarm
bypass / unbypass zones
silent arming
control the MONO switch and BI switch outputs
The control panel may be controlled from a telephone set which the control panel is
calling during voice messaging (immediately after playback of the message from the
voice synthesizer) or, after establishing connection, from any other telephone. Details
regarding the control panel operation - see the manual for MST-1 module.
Functions of  Key in the LCD Keypads
Activated by installer functions assigned to  keys help in everyday control of
the system operation. The function is called by pressing the corresponding key. The
installer can disable the functions described below.
Find the partition where alarm was activated key
In multi-partition systems the find function enables determining the partition where alarm
was activated. On calling, the function shows by means of
[ARMED] LEDs the
partitions where alarm was activated, and on the LCD display the names of partitions
(every time the key is pressed next partition name is shown).
Find the violated zones key
The function displays the names of violated zones. The zones are shown on pressing
the key (the function shows the partition zones as selected by the installer).
Find the zones that caused the alarm key
The function displays the zone names for which the alarm has not yet been cleared
(individual alarm memory for zones). Every time the key is pressed next zone name
is shown.
Find the partition where the keypad is attached key
The function displays the name of the basic partition operated with a keypad (the
partition to which the keypad is physically attached).
http://www.ealarm.com.my
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Komentáře k této Příručce

Žádné komentáře