Satel SATELLINE-M3-R3 Uživatelská příručka Strana 30

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 32
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 29
SATELLINE-M3-R3
Integration Guide, Version 1.6
29
"5" Turns ON Power Save mode
"6" Turns OFF Power Save mode
RadioFreq
SL!D?
Get lower limit of frequency band 1
"nnn.nnnnn MHz"
RadioFreq
SL!U?
Get upper limit of frequency band 1
"nnn.nnnnn MHz"
RadioFreq
SL!W?
Get lower limit of frequency band 2
"nnn.nnnnn MHz"
RadioFreq
SL!Y?
Get upper limit of frequency band 2
"nnn.nnnnn MHz"
RadioFreq
SL&+=nnnn
Set active frequency nnnn channels above
center frequency
Frequency = Center frequency +
nnnn*Channel spacing
Value of nnnn is [0...number of channels/2]
For conventional reasons, only 2 or 4 digit
inputs are valid
"OK" or "ERROR"
RadioFreq
SL&-=nnnn
Set active frequency nnnn channels below
center frequency
Frequency = Center frequency
nnnn*Channel spacing
Value of nnnn is [0…number of channels/2]
For conventional reasons, only 2 or 4 digit
inputs are valid
"OK" or "ERROR"
RadioFreq
SL&C?
Get center frequency
"nnn.nnnnn MHz"
RadioFreq
SL&F?
Get active frequency
"nnn.nnnnn MHz"
RadioFreq
SL&F=nnn.nnnn
n
Set active frequency to nnn.nnnnn MHz
"OK" or "ERROR"
RadioFreq
SL&N?
Get active channel calculated from center
frequency
( = (active frequency center
frequency)/channel spacing )
decimal number "+nnnn",
"-nnnn", "+nn" or "-nn"
RadioFreq
SL&W?
Get channel spacing/channel width
"25.0 kHz", "12.5 kHz" or
"20.0 kHz"
RadioFreq
SL&W=xxxx
Set channel spacing. Value of xxxx is:
”1250” for 12,5 kHz
”2000” for 20 kHz
”2500” for 25 kHz
Command is supported only by hardware
variants with adjustable
channel spacing
Before using this command, make sure that
active frequency
matches new channel spacing
"OK" or "ERROR"
RadioProperty
SL%F?
Get status of Error correction (FEC)
"0" = FEC OFF
"1" = FEC ON
RadioProperty
SL%F=x
Set Error correction (FEC). Value of x is:
"1" Set FEC ON
"0" Set FEC OFF
"OK" or "ERROR"
RadioProperty
SL%E?
Get status of Error check and Full CRC16
check modes
"0" Error check off
"1" CRC8 Partial
"2" CRC8 Full
"3" CRC16 Full
Zobrazit stránku 29
1 2 ... 25 26 27 28 29 30 31 32

Komentáře k této Příručce

Žádné komentáře