Satel SATELLINE-EASy Uživatelská příručka Strana 40

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 104
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 39
SATELLINE-EASy Pro
User Guide v.1.5
40
9 SETTINGS
The configuration of SATELLINE-EASy Pro can be easily changed. Simply by connecting MODE
pin (see chapter 6.2) of the data connector to ground (GND) the radio modem will switch into
Programming Mode. Serial PORT 1 is used whenever the radio modem is in the Programming
Mode. The serial port settings are 9600 bps, N, 8,1 (data transfer speed 9600 bps, none parity,
character length 8 bits and one (1) stop bit).
SATELLINE-EASy Pro contains push buttons and a LCD-display, which can be used to modify
configuration settings without the help of an external terminal device. The radio modem will switch
into Programming Mode by pressing the ”SETUP” ( )button.
9.1 Programming Mode
The settings of SATELLINE-EASy Pro are fully configurable in Programming Mode by using
following setup:
- Satel Configuration Manager software, or alternatively a terminal program (SaTerm,
HyperTerminal etc.)
- Power cable (C-P-35W)
- Data Cable (NARS-ST for 8-pin connector)
- Interface adapter (NARS-1F includes a mechanical switch for easy changing between the
Programing mode and Data Transfer mode)
The radio modem will shift into the Programming Mode by connecting MODE pin (see chapter
6.2) of the data connector to ground (GND). When using the NARS-1F, this can be accomplished
by moving the slide switch towards D-9 connector.
In the Programming Mode, the radio modem is forced to use serial PORT1, with settings 9600
bps, N, 8,1 (data transfer speed 9600 bps, none parity, 8 data bits and 1 stop bit).
9.2 Changing parameters using a terminal device
9.2.1 Changing the settings
Connect cables (RS-232 cable to PC COM-port, power supply cable to power supply).
Switch on the PC and start the terminal program.
Set the serial port parameters of the program as follows: 9600 bits/s, 8 data bits, none
parity, 1 stop bit, which is always the default in Programming Mode).
Zobrazit stránku 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 103 104

Komentáře k této Příručce

Žádné komentáře