Satel SMET-256 Uživatelský manuál stáhnout pdf (Strana 4)

2 SMET-256 SATEL

Explanations for Fig. 1:

1 – LED indicators:

PWR – power indicator – ON when power supply is connected

ST – status indicator:

− ON – RS-232 port working in RC4000 VISONIC, SurGuard (MLR2/MLR2E)

or RSM-02 receiver emulation mode

− blinking fast – replacement of converter firmware

− momentarily dimming – wrong converter configuration data (also on the

first-time run, before configuration)

− lights up momentarily – RS-232 port available for communication with the

computer

RI – ringing indicator – ON when the converter is calling the reporting station

OH – reporting station connection indicator:

− ON – connection to the monitoring station

− blinking – timeout of reporting station connection (converter is sending no

more data)

WT – handshake / kiss-off indicator:

− ON – waiting for handshake / kiss-off signal from the monitoring station

− blinking – there are data to be sent, but there is no kiss-off signal from the

monitoring station

ERR – trouble indicator:

− blinking fast – no Ethernet network cable

− 1 short blink, followed by a pause – the station is not answering the call

− 2 short blinks, followed by a pause – the station went off-hook, but no

handshake / kiss-off signal was received

− 3 short blinks, followed by a pause – the station hung up before all data were

sent

2 - RJ-45 socket for connection of the Ethernet network cable. Use the same cable as the

one for connecting computer to the network. The socket has two built-in indicator LEDs.

The green one indicates connection to the network and data transfer, and the yellow

one – negotiated transmission rate (ON: 100Mb; OFF: 10Mb).

3 - RJ socket (6P2C) for connection of the telephone cable, connecting the converter to

the monitoring station.

4 - power socket for connection of the 12 V DC power supply unit . The power

supply current capacity must be at least 750 mA.

5 - DB-9F socket (RS-232 port) for communication with the reporting station (emulation of

RC4000 VISONIC, SurGuard (MLR2/MLR2E) and RSM-02 receiver) or the computer.

3. CONVERTER INSTALLATION

1. Connect the Ethernet network cable to the RJ-45 socket.

2. Using telephone cable, connect the converter RJ socket with the reporting station

(emulation of analog telephone line), or connect the converter DB-9 socket with the

reporting station RS-232 port (emulation of RC4000 VISONIC, SurGuard (MLR2/MLR2E)

and RSM-02 receiver).

3. Connect power supply.

1 2 3 4 5 6 7 8 9 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Satel SMET-256 Uživatelský manuál Strana 4

Komentáře k této Příručce